Melaminfoil Particleboard
I S O 9 0 0 2 Q U A L
I T Y
M A N A G E M E N T S Y S T E M
Product description These
are pressed particleboards with melaminfoil from aminoplasfic materials.
The composition of the foil's layers is bilaterally symmetrical. The finish
of the melaminfoil particleboard is given by the imprint of the decorative
paper (UNI colors, wood-designs, art designs) and surface of the metal
plates (smooth, sob, engraving) used. The product characteristics are in
compliance with the STN 492628 standard.
Dimensions Length: 2 750 mm
+/- 5 mm
Width: 1 830 mm +/- 5 mm
Nominal thickness: 6, 8,10,12,13,15,16,18,19,22,25,
28, 32, 38 mn
Design Several types of surface finish
(depending on the used pressing plates) are available.
Smooth: available in the full range
of thickness
Some shallow available in the range
of thickness from 12 to 22 mm
Sobme deep: available in the full range
of thickness
Engraved beech 1: available in the
full range of thickness
Engraved beech 2: thickness from 12
to 22 mm
Engraved ash: available in the range
of thickness from 12 to 22 mn
ARTWOOD - available in the full range
of thickness
Physical and mechanical Humidity
at the time of shipment: 5 - 11%
choroderistics Density: max.
880 kg/m3
Absorbtion in water after 2 hour. max.
10% v v ,13 - 16 mm: 15 MPa; 18 mm and over: min. 14 MPa Transversal tensile
strength at right angles to the board: up to 12 mm thick: 0,35 MPa; 13
- 16 mm 0,30 MPa; 18 mm and over: 0,25 MPa The melaminfoil particleboard
complies with the E1 emission class. Combustibility according to the STN
730823 standard: C2 level
Pocking, delivery end storage The
boards are stored and delivered in stacks of 15 - 80 pieces (depending
on the specified thickness, the height of one stack is 57 cm approximately)
up to maximum weight of 2500 kg. The stacks are equipped with special protective
edges and fastened with banding strips. The bottom of each stack is protected
with protective cover material. Stacks are stored in climate-controlled
storehouses in order to maintain their specified humidity. The boards are
laid on flat surfaces on four support plates of identical height up to
five stacks high. The uniformly placed supports prevent deformations of
the bundles. The characteristics of melaminfoil particleboard are in compliance
with the ecological and sanitary standards of the Public Testing Institute
SKTC 113 in Lignotesting,Rrnti~lnvn
|
Awards
